(In the stress-strain curve shown here, the proportional limit and the elastic limit are assumed to be the same.)Īs long as the applied stresses are below the proportional limit, stress-strain relationships are the same whether the material is under tension or compression. For many materials, the proportional limit and the elastic limit are the same or nearly equal. Just beyond the proportional limit is the elastic limit, at which point the material transitions from elastic behavior, where any deformation due to applied stress is reversed when the force is removed, to plastic behavior, where deformations caused by stress remain even after the stress is removed. The modulus of elasticity is essentially a measure of stiffness and is one of the factors used to calculate a material’s deflection under load. Many materials exhibit a proportional relationship between stress and strain up to certain point, referred to as the proportional limit, shown here as point “A.” This stress-strain relationship is known as Hooke’s Law, and in this region, the slope of the stress-strain curve is referred to as the modulus of elasticity (aka Young’s modulus), denoted E. The stress-strain diagram provides valuable information about how much force a material can withstand before permanent deformation or failure occurs. The most common way to analyze the relationship between stress and strain for a particular material is with a stress-strain diagram. Note: A material’s change in length (L – L 0) is sometimes represented as δ. Strain is the deformation or displacement of material that results from an applied stress. Stress is the force applied to a material, divided by the material’s cross-sectional area.Ī 0 = original cross-sectional area (m 2) There are five fundamental types of loading: compression, tension, shear, torsion, and bending. The component’s reactions to these loads are described by its mechanical properties.įor components subjected to tension or compression - such as load-carrying balls and rollers, shafts mounted vertically, or fastening and joining hardware - the mechanical properties of stress and strain play an important role in determining whether the component can withstand the application’s loading conditions. Every component in a linear motion system experiences some form of loading due to applied forces or motion.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |